Describe the household need before choosing equipment.
Think about what an outage interrupts in your home: water from a well, refrigerated food, heating or cooling, lighting, or a place to work. Put the result you need beside the system involved. Your priorities can differ from a neighbor's even when the houses have similar floor plans.
Generac's sizing guidance distinguishes the appliances and systems to be supplied from the home's square footage and directs the final decision to a professional assessment. Use your priorities to explain the proposed job; they do not establish a generator size or confirm that a particular system can be supplied.
Generac: household loads and professional generator assessment
| Need to discuss | Useful information already at hand |
|---|---|
| Water and pumps | Whether the home uses a well or has a sump pump; available equipment details, or unknown. |
| Food storage | Which refrigerator or freezer matters to the household and where it is located. |
| Heating and cooling | The systems you use, what is known about their fuel and the rooms you want to discuss. |
| Lighting and everyday use | The rooms, communication equipment and ordinary activities you want to support. |
| Other planned changes | An addition, new appliance, workshop or EV charger being considered, even if undecided. |
These are discussion prompts, not a prescribed set of essential circuits. Use records and product information you already have. Do not open equipment or measure wiring to answer them.
Ask what coverage means during actual use.
There are two different questions: Is this system included in the backup plan? And can it operate at the same time as the other included systems? Ask both. A list of connected appliances alone does not explain every operating condition.
KOHLER's selection guidance considers both running demand and the additional power some equipment needs at startup. That is why an assessment needs the actual equipment and intended use, rather than a room count or a generic appliance list. Leave the calculations and equipment selection with the qualified people assessing the project.
A managed load needs an explanation.
Some backup configurations manage demand by temporarily turning off selected loads. For a specific example, KOHLER's Load Shed Kit describes turning off less critical loads when essential appliances are running. Its compatibility is limited to the transfer-switch and generator-controller combinations identified on that product page.
That example does not establish compatibility with your equipment or mean every generator includes that function. If load management appears in a proposal, ask which systems it affects, which take priority and what the household should expect while those systems are unavailable. Do not choose control settings from a general article.
KOHLER Load Shed Kit: behavior and specific compatibility limits
Read the proposal as an operating description.
Look for an explanation that connects the coverage description to your priorities. If a phrase remains broad, ask a concrete follow-up.
| Description in a proposal | Question to resolve |
|---|---|
| Selected systems | Which equipment or circuits are included, and which are outside this scope? |
| Whole-home coverage | What does this mean for the actual equipment here, and what limits apply to simultaneous use? |
| Load management | Which loads may pause, in what priority, and what should the household expect? |
| Future equipment | Was the proposed addition or appliance considered, or does it need a later assessment? |
Hypothetical example, not a Stamp installation: a homeowner wants to discuss the well pump, refrigerator and heating system, and asks whether vehicle charging could wait during an outage. That describes a preference for the assessment. It does not show that those loads fit a particular generator or prescribe how they should be connected.
Keep fuel and site questions with the coverage decision.
Tell the project team what you already know about the home's fuel supply and any preferred generator location. Mark unknown details plainly. A preferred spot remains a question until the actual equipment and property have been assessed.
Generac's standby FAQ directs location decisions to a site survey and the selected unit's installation guidance. Its products also require periodic maintenance. Ask what the proposed equipment requires, who would handle that work and which responsibilities are included in the proposal. A manufacturer's maintenance discussion is not a promise that Stamp offers a maintenance plan.
This guide does not select a fuel system, clearances, transfer equipment or an approval path. Those are project-specific questions. The manufacturer sources are examples of decision factors, not evidence that Stamp is an authorized dealer for either brand.